Name: RAT Training
Start: 2025-06-16T09:00:00-04:00
End: 2025-06-20T13:00:00-04:00
Location: https://bnl.zoomgov.com/j/1613945433?pwd=E43ZrPADyuQrsbEDGmfySbq2ewTbJi.1

Monday 16 June
- 09:00 → 09:10
  
  A Short Introduction to Rat and the Rat GUI
- 09:10 → 09:20
  
  General Geometry
- 09:10 → 11:20
  
  Modeling in Rat
- 09:20 → 09:40
  Cross-Sections
  1. Standard cross-sections
  2. Distmesh
- 09:40 → 10:20
  Paths
  1. Standard paths
  2. Path groups
  3. Cosine Theta coils
  4. Canted Cosine Theta
  5. XYZ table / file
- 10:20 → 10:40
  Transform Models
  1. Coil transformations
  2. Path transformations
- 10:40 → 11:20
  
  Path Groups
- 11:20 → 13:00
  
  Hands on Session 1
  
  Challenge to build complex coils in Rat GUI
Wednesday 18 June
- 09:00 → 09:10
  
  Questions About Hands-On Session 1
- 09:10 → 09:30
  
  Meshes, HB-Meshes, and Permanent Magnets
- 09:30 → 11:10
  
  Calculations in RAT 2: Calculations in RAT 1
- 09:30 → 09:50
  
  Multi-Level Fast Multipole Method
- 09:50 → 10:10
  
  Sources and Targets
- 10:10 → 10:30
  
  Iron and Other Non-Linear Materials
- 10:30 → 10:50
  
  Standard Calculations in RAT
- 10:50 → 11:10
  
  Mesh Calculation
- 11:10 → 13:00
  
  Hands on Session 2
  
  Continue your model, add calculations
Friday 20 June
- 09:00 → 09:10
  
  Questions About Hands-On Session 2
- 09:10 → 10:10
  
  Calculations in RAT 2
- 09:10 → 09:40
  
  Harmonics
- 09:40 → 10:10
  
  1D Adiabatic Quench
- 10:10 → 10:40
  
  Data Analysis in RAT and in ParaView: Data analysis in RAT and in ParaView
- 10:40 → 11:10
  
  Exporting Models For Use in Other Programs