RAT Training

Jun 16, 2025, 9:00 AM → Jun 20, 2025, 1:00 PM US/Eastern

https://bnl.zoomgov.com/j/1613945433?pwd=E43ZrPADyuQrsbEDGmfySbq2ewTbJi.1

Vikas Teotia (Brookhaven National Laboratory), Brett Parker (Brookhaven National Laboratory), Ramesh Gupta (Brookhaven National Laboratory)

Mon, June 16

9:00 AM → 9:10 AM A Short Introduction to Rat and the Rat GUI

9:10 AM → 9:20 AM General Geometry

9:10 AM → 11:20 AM Modeling in Rat

9:20 AM → 9:40 AM Cross-Sections

1. Standard cross-sections
2. Distmesh

9:40 AM → 10:20 AM Paths

1. Standard paths
2. Path groups
3. Cosine Theta coils
4. Canted Cosine Theta
5. XYZ table / file

10:20 AM → 10:40 AM Transform Models

1. Coil transformations
2. Path transformations

10:40 AM → 11:20 AM Path Groups

11:20 AM → 1:00 PM Hands on Session 1

Challenge to build complex coils in Rat GUI

Wed, June 18

9:00 AM → 9:10 AM Questions About Hands-On Session 1

9:10 AM → 9:30 AM Meshes, HB-Meshes, and Permanent Magnets

9:30 AM → 11:10 AM Calculations in RAT 2: Calculations in RAT 1

9:30 AM → 9:50 AM Multi-Level Fast Multipole Method

9:50 AM → 10:10 AM Sources and Targets

10:10 AM → 10:30 AM Iron and Other Non-Linear Materials

10:30 AM → 10:50 AM Standard Calculations in RAT

10:50 AM → 11:10 AM Mesh Calculation

11:10 AM → 1:00 PM Hands on Session 2

Continue your model, add calculations

Fri, June 20

9:00 AM → 9:10 AM Questions About Hands-On Session 2

9:10 AM → 10:10 AM Calculations in RAT 2

9:10 AM → 9:40 AM Harmonics

9:40 AM → 10:10 AM 1D Adiabatic Quench

10:10 AM → 10:40 AM Data Analysis in RAT and in ParaView: Data analysis in RAT and in ParaView

10:40 AM → 11:10 AM Exporting Models For Use in Other Programs